Scandium Nitrate
MATERIAL SAFETY DATA SHEET
I. PRODUCT IDENTIFICATION
Manufacturer/Supplier:
ESPI Metals
1050 Benson Way, Ashland, OR 97520
Toll Free (800) 638-2581 * Fax (541) 488-8313
E-Mail: This email address is being protected from spambots. You need JavaScript enabled to view it.
Product Name: Scandium Nitrate
Formula: Sc(NO3)3*xH2O
CAS Number: 13465-60-6
II. HAZARDOUS INGREDIENTS
Hazardous Components: Scandium Nitrate
Percent (%): 100
OSHA/PEL: Not established
ACGIH/TLV: Not established
III. PHYSICAL DATA
Boiling Point: No data
Melting Point: -4H2O,100
Specific Gravity: No data
Solubility in H2O: Soluble
Hygroscopicity: Yes
Appearance and Odor: Colorless, deliquescent crystalline aggregates.
IV. FIRE AND EXPLOSION HAZARDS DATA
Flash Point (Method Used): No data
Autoignition Temperature: No data
Flammable Limits: Upper: Not applicable Lower: Not applicable
Extinguishing Media: Use water, carbon dioxide, dry chemical extinguishing agents, dry sand or dry dolomite.
Unusual Fire and Explosion Hazards: Inorganic nitrates act as oxygen carriers. Under proper conditions they can give up their oxygen to other materials, which in turn detonate.
V. HEALTH HAZARD INFORMATION
Effects of Over Exposure: Material is highly toxic via intraperitoneal route. Details of toxicity are not known but material should be handled carefully. Material is irritating to skin, eyes, and mucous membranes.
EMERGENCY AND FIRST AID PROCEDURES: Remove from exposure.
EYES: Flush with copious amounts of water for at least 15 minutes. Seek medical attention if necessary.
SKIN: Flush with copious amounts of water. Seek medical attention if necessary.
INHALATION: Remove from area of exposure. Get medical attention as needed.
INGESTION: No specific information available. One should seek prompt medical attention.
VI. REACTIVITY DATA
Stability: Stable
Incompatibility (Material to Avoid): Organic materials, Reducing materials.
Conditions to Avoid: Organic materials, reducing materials.
Hazardous Polymerization: Will not occur
Hazardous Decomposition Products: NO fumes.
VII. SPILL OR LEAK PROCEDURES
Steps to Be Taken If Spilled or Released: Wearing full respiratory and protection equipment eliminate all sources of ignition. Cover spill with dry sand or dry vermiculite, mix well and carefully transfer to a well-marked container. Close tightly and submit or retain for disposal.
Waste Disposal Method: Dispose of in accordance with Local, State and Federal regulations.
VIII. SPECIAL PROTECTION INFORMATION
Respiratory Protection (Specify Type): NIOSH/MSHA approved dust mask. For emergencies a self-contained breathing apparatus.
Ventilation Requirements: Local Exhaust: Fume hood.
Eye Protection: ANSI approved safety goggles, and face shield.
Gloves: Rubber
Special Note: Safety drench shower and eyewash capable of sustained flushing.
Other: Lab coat and apron, flame and chemical resistant coveralls. Safety glasses or goggles, gloves, protective clothing, and chemical respirator recommended.
IX. SPECIAL PRECAUTIONS
Transportation Data:
Oxidizing solid, n.o.s.
Class 5.1
UN1479
The above information is believed to be correct, but does not purport to be all inclusive and shall be used only as a guide. ESPI shall not be held liable for any damage resulting from handling or from contact with the above product.
Issued by: S. Dierks
Issue Date: February 1994