ELECTRONIC SPACE PRODUCTS INTERNATIONAL
1050 Benson Way, Ashland, OR 97520
Toll Free (800) 638-2581 * Fax (541) 488-8313
E-Mail: sales@espimetals.com
MATERIAL SAFETY DATA SHEET
I PRODUCT IDENTIFICATION
Trade Name: Iridium (III) Chloride Hydrate Formula: IrCl3 ⋅ 3H2O
CAS #: 13569-57-8
II HAZARDOUS INGREDIENTS
Hazardous Components % OSHA/PEL ACGIH/TLV
Iridium (III) Chloride 0-100 1.0 mg/m3 1.0 mg/m3
III PHYSICAL DATA
Boiling Point: N/E or N/A Melting Point: Decomposes
Specific Gravity: N/E or N/A Vapor Density: N/A
Vapor Pressure: N/A Solubility in Water: Soluble
Appearance and Odor: Black/brown crystalline powder, odor of chlorine
IV FIRE AND EXPLOSION HAZARDS DATA
Flash Point: N/A Flammable Limits: Non-flammable
Flammable Limits: Lower: N/A Upper: N/A
Extinguishing Media: CO2, Foam, dry chemical.
Special Firefighting Procedures: Self-contained breathing apparatus. Fully protective impervious suit.
Unusual Fire and Explosion Hazards: May emit toxic fumes of Cl2 upon decomposition.
V HEALTH HAZARD INFORMATION
Effects of Exposure:
To the best of our knowledge the chemical, physical and toxicological properties of iridium chloride have not been thoroughly investigated and reported. Exposure to iridium compounds may cause irritation to the eyes or respiratory tract. Toxicity of iridium is not known. It is predicted to have toxicity similar to osmium and platinum, two members of the same group. The chloride ion generally has a very low toxicity.
Acute Effects:
Inhalation: Irritant
Ingestion: No data
Skin: Irritant
Eye: Irritant
Chronic Effects: No data
Sensitization: No sensitizing effects known.
Carcinogenicity: EPA: No IARC: No NTP: No OSHA: No ACGIH: No
EMERGENCY AND FIRST AID PROCEDURES:
INHALATION: Remove patient from area of exposure to fresh air. If required, provide artificial respiration. Keep patient warm. Contact a physician immediately.
INGESTION: Contact poison control center/physician immediately.
SKIN: Immediately wash with soap and water for 15 minutes and rinse thoroughly. Seek immediate medical advice.
EYE: Flush with eye bath, including under eyelids, for at least 15 minutes. Consult a doctor.
VI REACTIVITY DATA
Stability: Stable
Conditions to Avoid: Extreme heat
Incompatible Materials: Oxidizers, acids, alkalis, organic solvents, metal powder.
Hazardous Decomposition Products: Chlorine, iridium, hydrochloric acid.
Hazardous Polymerization: Will not occur
VII SPILL OR LEAK PROCEDURES
Steps to Be Taken in Case Material Is Released or Spilled: Sweep up and place in airtight plastic container. Ship to precious metal refiner.
Waste Disposal Method: Dispose of in accordance with all State, Federal and Local regulations.
VIII SPECIAL PROTECTION INFORMATION
Respiratory Protection: NIOSH/MSHA approved.
Ventilation: Fume hood
Protective Gloves: Rubber for all contact
Eye Protection: Goggles
Other Protective Equipment: Normal labwear.
IX SPECIAL PRECAUTIONS
Precautions to Be Taken in Handling and Storage: Store in cool, dry place, keep tightly sealed when not in use, read MSDS before using.
Labeling: In compliance with OSHA and NFPA requirements.
Work Practices: Implement engineering and work practice controls to reduce and maintain concentration of exposure. Use good housekeeping and sanitation practices. Do not use tobacco or food in work area. Wash thoroughly before eating or smoking. Do not blow dust off clothing or skin with compressed air. Maintain eyewash capable of sustained flushing, safety drench shower and facilities for washing.
The above information is believed to be correct, but does not purport to be all inclusive and shall be used only as a guide. ESPI shall not be held liable for any damages resulting from handling or from contact with the above product.
Issued By: S. Dierks
Date: November 2004